Appendix A: Gel Doc 2000 System Installation - BIO RAD Gel Doc 2000ChemiDocChemiDoc XRS Hardware Instruction Manual

Appendix A: Gel Doc 2000 System installation

The following appendix gives additional information to use the Universal Hood in the Gel Doc 2000
configuration.
Connecting the cabling harnesses
a) Carefully take the CCD camera assembly out of the box and hold the camera so that the two
locking holes are facing you.
b) Insert it into the camera holder from the open left side and attach it with the two black screws.
c) Place the bracket with the camera on the top of the Hood and attach it with the four washers and
knobs.
d) Carefully unpack the 170-7546 integration cable. The power cable should be already plugged into
the CCD camera 12 V AC/DC connector.
e) Connect each end of the CCD Camera cable following the instruction below:
Label / Color
9-pin connector / Black
Camera Video / BNC Black
Camera AUX / Multi Pin Red cable
12 V AC-DC / Black cable two poles
12 V Power Cable / Metal end
NOT USED
WITH THE
CCD
GD 2000
12 V AC/DC
output to the
CCD Camera
Multi pin from MZL
Serial port DB25 to connect a null
modem serial cable from PC Com1 port.
This option permits to control the MZL
directly from a program on the PC.
Page 36 of 42
Instrument / Connection
PCI board / Back of computer
CCD Camera / Video
CCD Camera / AUX
Camera / 12 V AC-DC
Hood / Mini Din
Multi pin (Aux) connector.
Red cable to PCI
12 V AC/DC input
connected to the rear
left side
BNC black cable to the PCI