Appendix A: Gel Doc Xr System Cable Configuration - BIO RAD Gel Doc XR 170-8170 Instruction Manual

Appendix A: Gel Doc XR System Cable Configuration
Connecting the cabling harnesses
a) Locate the Fire Wire cable. Connect one end of the Fire Wire cable connector to the Fire Wire
connector on the Camera and connect the other end to the Fire Wire connector on the PC/Mac
b) The Camera power supply cable should be plugged into the CCD Camera PWR connector.
c) Connect the serial cable to the connector labeled "SERIAL" on the hood and the other end of
this cable to the appropriate port on the PC or Mac USB to Serial Adapter.
d) Connect the MZL cable connector to the connector labeled "LENS" on the rear panel of the
universal hood.
The following table describes the connectors and their designations.
Label / Color
6-pin Fire Wire connector
6-pin Fire Wire connector
Camera Power Supply Cord/Power Supply
25 Pin D-SUB Serial Cable connector
5 pin DIN Cable from Motorized Zoom Lens
MZL
CABLE
Instrument / Connection
Fire Wire Connector of the PC or PCI Card
CCD Camera Fire Wire Connector
Camera / PWR Connector
COM1 PORT/Back of Computer
Hood / LENS connector
Power Cable
from Power
Fire Wire Cable
SERIAL CABLE
Page 35 of 42
Supply
To Mains
110-240 VAC