BIO RAD Gel Doc 2000ChemiDocChemiDoc XRS Hardware Instruction Manual page 12

Please refer to the instructions included in Appendix B for a complete description of the cables
connection.
ChemiDoc XRS Camera: (170-8078)
NOTE: For this installation you will require Camera Bracket Assembly 1708079.
a) Carefully take the Camera bracket assembly out of the box and set it on a clean table as
shown below:
Lens Center
adjustment screw
b) Carefully take the CCD camera assembly out of the box. The Camera assembly package
consists of a Cable, Power supply, Camera Assembly with Motorized Zoom lens and +1
diopter assembled to it and a PCI digitizing card.
c) Hold the camera so that the tripod mount is facing away from your hand (see picture below):
d) Using the black knob and washer provided in the packaging for the Camera Bracket
assembly, assemble the Camera assembly to the bracket. Do not completely tighten the knob
to allow further adjustment to the Camera position in the bracket assembly.
e) Lower the camera assembly so that the lens fits properly in the opening in the black adapter
plate with a rubber gasket.
Camera Bracket Assembly (170-8079)
Camera Assembly 170-8078
Black Knob Camera + Bracket Assembly
Page 12 of 42
Tripod Mount!