Tm Pulse 2X24V Feedback Interface - Siemens SIMATIC ET 200SP Manual

6.3

TM Pulse 2x24V feedback interface

Your program receives current values and status information from the technology module by
means of the feedback interface.
Feedback interface
The following table shows the assignment of the feedback interface for one channel
Bit → 7
Byte
↓
00 ERR_SLOT_ ERR_OUT_
VAL VAL
01 Reserved
02 Reserved
03
04
05
06
07
Feedback parameters
Table 6- 1 Status feedback
Feedback parameter
STS_READY
STS_SW_ENABLE
STS_LD_SLOT
STS_ENABLE
STS_DQA
STS_DQB
STS_DI
STS_DITHER
SEQ_CNT
Technology module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 09/2015, A5E35061186-AA
6 5
ERR_DQB ERR_DQA
STS_SW_ STS_READY
ENABLE
STS_DITHER STS_DI
Reserved
Reserved
Meaning
Module is parameterized correctly, running, and
delivering valid data.
Current state of the software enable
Toggle acknowledge bit for each action of the SLOT
in single-update SLOT-mode.
Output sequence is active.
State of digital output DQn.A
State of digital output DQn.B
DIn.0: State of digital input
Dithering state
Counts completed output sequences
4 3
ERR_PULSE
Reserved
MEASURED_CURRENT
Reserved
Program control and feedback interface
6.3 TM Pulse 2x24V feedback interface
2 1
ERR_LD ERR_24V
STS_LD_SLO Reserved
T
STS_DQB STS_DQA
SEQ_CNT
QLMN_HLM
Value range
0: Not ready
1: Ready
0: SW_ENABLE is not active
1: Recognized SW_ENABLE
Each toggle of this bit indicates a suc-
cessful LD_SLOT action.
0: No output sequence running
1: Output sequence running
0: DQn.A is not active
1: DQn.A is active
0: DQn.B is not active
1: DQn.B is active
0: DIn.0 is not active
1: DIn.0 is active
0: Dithering inactive
1: Dithering active with ramp-up phase
started and ramp-down not complete.
0 to 15
0
ERR_PWR
STS_ENABLE
QLMN_LLM
115