Siemens SIMATIC ET 200SP Manual page 53

Isochronous mode
General information is available in Function: Isochronous mode (Page 86).
Isochronous mode does not have any influence on the functionality of On/Off-delay operating
mode.
Parameters for On/Off-delay operating mode
Parameter
Mode
High Speed Output
1
Function DI
Input Delay
Off-delay
Only if the module is configured as "2 channels (2 A)" and not "1 channel (4 A)".
1
Technology module TM Pulse 2x24V (6ES7138‑6DB00‑0BB1)
Manual, 09/2015, A5E35061186-AA
Meaning
3 = Set the "On/Off-delay" operating
mode.
The output supports higher fre-
quencies.
You can only use the DIn.0 digital
input as an input.
DI digital input must be stable over
the delay time (signal noise sup-
pression).
The time from the falling edge of the
DIn.0 digital input to the falling edge
of the DQn.A. You can change the
Off-delay in your control program
using the SLOT parameter.
Value Range
0 = Pulse output
1 = Pulse width modulation
2 = Pulse train
3 = On/Off-delay
4 = Frequency output
5 = DC-Motor
0 = disabled
1 = enabled
0 = Input
1 = reserved (do not use)
0 = Off (4 μs)
1 = 0.05 ms
2 = 0.1 ms
3 = 0.4 ms
4 = 0.8 ms
5 = 1.6 ms
6 = 3.2 ms
7 = 12.8 ms
8 = 20 ms
0 μs to 85,000,000 μs
Modes and Functions
3.5 On/Off-delay mode
Default
1
Disabled
Input
0.1 ms
0 μs
53