6060H Object- Modes Of Operation; 6061H Object- Modes Of Operation Display; Velocity Mode - Objects For Controlling The Drive - WEG CFW-11 Communications Manual

The other bits indicate a specific condition for the drive.
Voltage enabled
Bit 4 –
Warning
Bit 7 –
Remote
Bit 9 – : indicates when the drive is in the remote mode and accepts commands via the CANopen
network. It represents the Statusword bit 4 value – P0680.
Target reached
Bit 10 –
the used operation mode. It is also set to 1 when the functions
Internal limit active
Bit 11 –
limit for instance.
Operation mode specific
Bits 12 e 13 –
6.1.3 6060h Object– Modes of Operation
It allows programming the CFW-11 operation mode.
The only mode supported by the CFW-11 inverter is the
6.1.4 6061h Object– Modes of Operation Display
It indicates the CFW-11 operation mode.
The only mode supported by the CFW-11 inverter is the
Velocity Mode
6.2
This operation mode allows the control of the inverter in a simple manner, making available functions of the
following type:
Reference value calculation.
Capture and monitoring of the speed.
Speed limitation.
Speed ramps, among other functions.
These functions are executed based on a set of objects for the configuration of that operation mode.
8 It depends on the inverter programming.
: indicates that the drive power section is being fed.
: It is not used for the CFW-11.
: indicates when the drive is operating at the reference value, which depends on
: indicates when the drive is operating at an internal limit value, as current
Index
Name
Object
Type
Used parameters
Access
Mappable
Range
Default value
Index
Name
Object
Type
Used parameters
Access
Mappable
Range
Default value
– Objects for Controlling the Drive
Quick stop
: they depend on the drive operation mode.
6060h
Modes of operation
VAR
INTEGER8
-
rw
Yes
INTEGER8
-
Velocity Mode
, represented by the value 2.
6061h
Modes of operation display
VAR
INTEGER8
-
rw
Yes
INTEGER8
-
Velocity Mode
, represented by the value 2.
Halt
or are activated.
8