6049H Object- Vl Velocity Deceleration; Position Control Function - Objects For Position Control; 6063H Object-Position Actual Value - WEG CFW-11 Communications Manual

The acceleration value is calculated dividing the speed programmed at the sub-index 1 by the time programmed at
the sub-index 2. The programmed values must respect the parameter P0100 allowed value range.
6.2.7 6049h Object–
It allows programming the inverter deceleration ramp.
Index
Name
Object
Type
Used parameters
Sub-index
Description
Access
Mappable
Range
Default value
Sub-index
Description
Access
Mappable
Range
Default value
Sub-index
Description
Access
Mappable
Range
Default value
The deceleration value is calculated dividing the speed programmed at the sub-index 1 by the time programmed at
the sub-index 2. The programmed values must respect the parameter P0101 allowed value range.
Position control function
Despite not supporting the position control operation mode, the objects related to this function were made available
in the CFW-11 inverter.
6063h Object–
It informs the encoder pulse counter value. This counter is valid only if the inverter has the accessory for the
interface with the encoder. This object value is increased until reaching the encoder number of pulses, being reset
when reaching this value.
Sub-index
Description
Access
Mappable
Range
Default value
vl velocity deceleration
– Objects for position control
Position actual value*
Index
Name
Object
Type
Used parameters
2
Delta time
rw
Yes
UNSIGNED32
-
6049h
vl velocity deceleration
RECORD
Vl velocity acceleration deceleration record
P0101
0
Number of the last sub-index
ro
No
2
2
1
Delta speed
rw
Yes
UNSIGNED32
-
2
Delta time
rw
Yes
UNSIGNED32
-
6063h
Actual position value
VAR
INTEGER32
P0681