Omron CJ1W-CT021 Operation Manual page 42

Operating Procedure Guidelines
Unit Configuration
Configuration 1
1, 2, 3...
22
3. Install and wire the Unit. Refer to 2-2 "Installation" and 2-3 "Wiring" for further
details.
4. Turn ON the Power to the PLC.
Power ON
5. Create the I/O table. The I/O table can be created by using CX-Programmer
Support Software or a Programming Console.
CX-Programmer
Programming Console
After the I/O table is created in step 5, you have to configure the Unit if you have
chosen for Configuration 2 or 3 in step 1. Configuration is done by making the
appropriate DM-settings. The Unit can be configured by using CX-Programmer
Support Software or a Programming Console. Two Programming Consoles can be
used with the CJ-series CPU Units: the C200H-PRO27-E and the CQM1-PRO01-
E. CS1W-KS001 Key Sheet must be used for both.
Depending on the Configuration (1, 2 or 3) that you specified in step 1, you should
continue with the corresponding step of the configuration-process:
All Counters as Simple Counters:
1. No (DM-) configuration settings can be made. The Unit is ready to count and
will use all default DM-values. All data related to the Simple Counter is now
being exchanged between the PLC and the Unit in CIO-memory and available
for usage in the PLC Ladder Program.
2. Create and RUN a Ladder Program in the PLC. Refer to SECTION 4 "Exchang-
ing Data with CPU" for details on the interface between the High-speed Counter
Unit and the CPU. Section 6-1 "Flow Control" describes an application example
using the Simple Counter.
Section 1-5