Reset Signals
Software Reset Enable Bit
as Reset Enable Source
CNT1:
CNT2:
n+2
n+5
Digital Input as Reset
Enable Source
82
Resetting the Counter Value to zero by Digital Input or Z-Signal must be enabled.
Enabling can be done by setting the Software Reset Enable Bit in CIO for the cor-
responding Counter to 1.
15 14 13 12 11 10 9
8
In order to use a Digital Input as Reset Enable Source you must assign Function
15 or 16 (= Enable/Disable Reset) to the corresponding Digital Input. Refer to 3-4
"Digital Input Functions" for more information.
7
6
5
4
3
2
1
0
0 = Resetting by Digital Input or Z-Signal Disabled
1 = Resetting by Digital Input or Z-Signal Enabled
Section 3-6
Software Reset Enable Bit: