Omron CJ1W-CT021 Operation Manual page 129

Memory Allocation
Word
m+48, m+49 00-15
m+50, m+51 00-15
m+52, m+53 00-15
m+54, m+55 00-15
m+56 00
01
02-15
m+57, m+58 00-15
m+59, m+60 00-15
m+61, m+62 00-15
m+63 00-15
m+64 00-07
08-15
m+65** 00-03
04-15
m+66, m+67** 00-15
m+68 to m+74 00-15
Bit Item
Rate-Range 1
Lower Limit
Rate-Range 1
Upper Limit
Set Pattern
Rate-Range 1
Reset Pattern
Rate-Range 1
Rate-Range 0 Enable
Rate-Range 1 Enable
---
Range / Comparison
Enable Data
Output Set Pattern
Output Reset Pattern
Hysteresis
# Ranges /
Comparison Values
---
Memory Area
---
Memory Address
---
* Set to "0" and turn OFF Hysteresis to use the Preset function.
** Sets the beginning (k1) of the Range Data or Comparison Data.
Rate-Range 1 Lower Limit
Rate-Range 1 Upper Limit
Output Set Pattern Rate-Range 1
Output Reset Pattern Rate-Range 1
Enable (=1) / Disable (=0) Rate-Range 0
Enable (=1) / Disable (=0) Rate-Range 1
Not used
Enable Ranges / Comparison Values (1=Enabled,
0=Disabled) (depending on Unit in Range /
Comparison Mode).
Bits set for non-existing ranges or CV's will be ignored
Output [0-31] Set Pattern for Comparison Mode
1= set, 0 = no change
Output [0-31] Reset Pattern for Comparison Mode
1= reset, 0 = no change
Define required Hysteresis (0000 to 00FF Hex) (0 ≤
Hysteresis ≤ 255 counts).
Hysteresis (=0) means Hysteresis is OFF.*
Set number of Ranges/ Comparison Values
[0, 32 ]
(BCD)
Not used
Memory Area where Range / Comparison Data is stored:
0 = EM (=default)
1 = DM
Not used
Beginning Address (in EM/DM) where first Range /
Comparison Data is stored [00000, 32760
Not used
Section 4-2
Function
(BCD)
]
109