Brother DCP-L5500D Service Manual page 384

(11) Release the heater harness of the fuser unit from the securing fixtures, and disconnect it
from the low-voltage heater harness.
Low-voltage heater harness
Assembling Note:
• After connecting the heater harness, pull the connector on the heater harness side while
holding the connector on the low-voltage heater harness side to make sure it is locked.
Harness routing: Refer to
(12) Disconnect the center thermistor harness and the side thermistor harness from the eject
sensor PCB ASSY.
Note:
• When disconnecting the harness, hold the top of the PCB connector to prevent the
PCB connector being damaged.
Eject sensor PCB ASSY
Fuser unit
Side thermistor
harness
Harness routing: Refer to
<Frame R side>
Heater harness
Fig. 7-6
"11. Rear side of the
<Frame L side>
Fig. 7-7
"11. Rear side of the
7-5
Fuser unit
machine".
Center thermistor
harness
machine".
Confidential