Table of Contents
Advertisement
For models with 250-sheet T1
(8) Remove the taptite cup S M3x8 SR screw and two taptite bind B M4x12 screws to
remove the under bar front.
(9) Remove the main PCB insulation sheet (transparent) and the main PCB insulation sheet
(black).
Assembling Note:
• Make sure that the black main PCB insulation sheet is inserted properly into the hole
of the transparent main PCB insulation sheet as shown in the illustration below.
(10) Turn the registration roller bushing on the registration roller shaft to the position as
shown in the figure below, and pull out the registration roller shaft.
Main PCB insulation
sheet (transparent)
Main PCB insulation
sheet (black)
Registration roller shaft
Fig. 3-94
3-94
Registration roller bushing
Taptite cup S M3x8 SR
Under bar front
Taptite bind
B M4x12
Confidential
Advertisement
Table of Contents
Troubleshooting
