Brother DCP-L5500D Service Manual page 64

Error message
First line
No Tray T3 Reinstall Tray 3.
No Tray T4 Reinstall Tray 4.
Out of Memory Press Stop[x].
Output Tray Full Remove the paper
from the Standard
Output Tray.
Paper Low Paper Low T1
Paper Low T2
Paper Low T3
Paper Low T4
Paper Low T5
Print Data Full Print Data is full.
Press Stop[x] Key and
delete the previously
stored data.
Print Unable ZC Turn the power off and
then back on again.
Print Unable ** Turn the power off and
then back on again.
Second line
When printing from paper tray 3 to
5, the T3(LT or TT) paper feed
sensor detected open paper tray 3
(before registering printing data to
engine).
When printing from paper tray 3 to
5, the T3(LT or TT) paper feed
sensor detected open paper tray 3
(after registering printing data to
engine).
When printing from paper tray 4 to
5, the T4(LT or TT) paper feed
sensor detected open paper tray 4
(before registering printing data to
engine).
When printing from paper tray 4 to
5, the T4(LT or TT) paper feed
sensor detected open paper tray 4
(after registering printing data to
engine).
There is insufficient memory to
expand PC print data.
Machine stack sensor detected
the eject paper full state at the
start of printing when the machine
output tray was selected as the
output tray.
Tray1 paper level is low.
Tray2 paper level is low.
Tray3 paper level is low.
Tray4 paper level is low.
Tray5 paper level is low.
The memory size allotted for
Secure Print was exceeded when
saving Secure Print data.
Detected irregular power supply
for less than 100 times.
Printing related error. Refer to
error code "**".
2-29
Description
Error Refer
codes to:
8503 2-63
8507 2-64
8504 2-63
8508 2-64
C700 2-79
8702 2-64
--- 4.14.4
--- 4.14.4
--- 4.14.4
--- 4.14.4
--- 4.14.4
C800 2-79
6F00 2-50
--- ---
Confidential