Paper Is Fed At An Angle - Brother DCP-L5500D Service Manual

4.2.7 Paper is fed at an angle

<User Check>
• Check that the paper is set in each paper tray correctly.
• Flip over the paper in each paper tray or rotate the paper 180°.
• Adjust each paper guide according to each paper size.
• Check that the thickness of the paper is 60 to 120 g/m
and 60 to 200 g/m
• Check that there is not too much paper set in each paper tray.
• Check that each type of paper is appropriate.
• Clean each paper pick up roller.
• Check that the green envelope lever is not lowered on only one side.
• Replace the drum unit.
• Replace the toner cartridge.
Step
Tray guide coming off on the
1
machine side
One-side abrasion of the paper
2
pick up rollers
Damaged gears in the paper
3
feeding system
Tray guide
2
for MP tray.
Cause
Fig. 2-11
2-87
2
for paper tray 1 to 5,
Remedy
Reattach the tray guide on the machine side.
Refer to the figure below.
Replace the PF kit.
Replace the main frame L ASSY.
Tray guide
Confidential