Brother DCP-L5500D Service Manual page 257

Note:
• Do not allow the metallic gear shaft of the paper feed motor and drive sub ASSY to face
down. Failure to observe this may cause the steel plate to bend.
(2) Remove the four taptite cup S M3x8 SR screws, and remove the paper feed motor plate
from the drive sub ASSY.
(3) Remove the fuser gear 35/83R and the DRM gear 32/83R from the paper feed motor
plate.
Note:
• Be careful not to damage the gear teeth.
(4) Remove the three screw bind M3x4 screws, and remove the paper feed motor from the
paper feed motor plate.
(5) Disconnect the paper feed motor harness from the paper feed motor.
Paper feed motor
Paper feed
motor harness
Screw bind M3x4
b
c
Assembling Note:
• When securing the paper feed motor on the drive sub ASSY with screws, tighten the
screws in the sequence of the alphabets engraved on the drive sub ASSY.
Paper feed motor plate
DRM gear 32/83R
Fuser gear 35/83R
Drive sub ASSY
a
d
Fig. 3-97
3-97
Drive sub ASSY
Taptite cup S M3x8 SR
Confidential