Brother DCP-L5500D Service Manual page 66

Error message
First line
Self-Diagnostic Turn the power off,
then on again.
Leave the machine for
15 min.
Will automatically
restart within 15
minutes.
Service Error XX Please contact service
engineer.
Size Error Specify the correct
paper size for Tray1.
Specify the correct
paper size for Tray2.
Specify the correct
paper size for Tray3.
Specify the correct
paper size for Tray4.
Specify the correct
paper size for Tray5.
Size Error Press [OK].
2-sided Specify the correct
paper and load the
same size paper as
the Printer driver
setting.
Specify the correct
paper.
Second line
An error occurred in the fuser unit
when the power switch was turned
ON or sleep mode was released.
Rechecking the error after the
power switch was turned OFF and
then ON again because an error
was detected in the fuser unit.
(This message is displayed for
approximately 15 minutes when
the machine is restarted after error
code 6901 has occurred.)
Failed to authenticate the firmware
for the self test.
Failed to authenticate the NVRAM
for the self test.
When printing from paper tray 1, a
paper size not supported for paper
tray 1 was specified from the
driver.
When printing from paper tray 2, a
paper size not supported for paper
tray 2 was specified from the
driver.
When printing from paper tray 3, a
paper size not supported for paper
tray 3 was specified from the
driver.
When printing from paper tray 4, a
paper size not supported for paper
tray 4 was specified from the
driver.
When printing from paper tray 5, a
paper size not supported for paper
tray 5 was specified from the
driver.
A tray set to duplex printing-
incompatible size was specified in
duplex printing.
The registration rear sensor
detected that the paper fed was
smaller or larger than the specified
size in duplex printing mode.
2-31
Description
Error Refer
codes to:
6901 2-49
6902 2-49
ED00 2-81
EE00 2-81
9702 2-72
9703 2-72
9704 2-72
9705 2-72
9706 2-72
9701 2-72
8A01 2-65
Confidential