Latch-Locking Power Supply; Specifications - Binary B-520-EXT-330-RS-IP Installation Manual

6.7. Thread-Locking Power Supply
This extender pair is Power over Cable capable and therefore can be powered from either
the transmitter or receiver. When a power supply is connected to either the transmitter or
receiver, the HDBaseT link sends power to the other end.
CAUTION: Do not connect the power supply to the device until it is completely installed
and all connections have been made.

7. SPECIFICATIONS

Technical
HDMI Compliance
HDCP Compliance
Video Bandwidth
HDMI over UTP Transmission
Input TMDS Signal
Input DDC Signal
ESD Protection
IR Signal (Bidirectional)
Connections
HDBaseT Link
HDMI
IR Receiver (In)
IR Flasher (Out)
RS-232 passthrough
IP pass-through
Power
Controls
DIP switch 1
DIP switch 2
DIP switch 3
DIP switch 4
Mechanical
Housing
Dimensions
Transmitter
HDMI 3D
Yes
10.2 Gbps
Cat 5e/6/6a/7
1.2V (peak-to-peak)
5V (peak-to-peak, TTL)
(1) Human body model: ±5kV (air-gap discharge) & ±8kV (contact
discharge) (2) Core chipset — ±8kV
Carrier frequency: 20–60kHz
1x RJ45
1x HDMI Type A
(19-pin female)
3.5mm Stereo/Mono
1x 3.5mmMono
DB-9
Ethernet
Latch-Locking
IR RCVR PWR OFF/ON
RS-232 Pin Configuration (DCE /DTE)
RS-232 Operation Mode (SERVICE/LINK)
EDID – HDBT EDID/
AUTO EDID
Metal enclosure
6.25" x 3.1" x 1.3"
14
Receiver
1080i/720p 24-bit color: 330'
Full HD 1080p 24-bit color: 330'
Full HD 1080p 36-bit color: 330'
Ultra HD 4K2K@30 Hz 330'
1x RJ45
1x HDMI Type A
(19-pin female)
1x 3.5mm Stereo/Mono
1x 3.5mm Mono
DB-9
Ethernet