Assembly Instructions - BodyCraft VR400-RW45 Owner's Manual

VR400 ROWER ASSEMBLY INSTRUCTIONS
STEP 1
Clear a 6 X 9 foot working space before unpacking your
VR400 Rower.
STEP 2
Open the carton as shown in the diagram below.
NOTE: To protect the Dual Mode Rower while assem-
bling we suggest that you do not remove the protective
Packing Material until it is absolutely necessary.
STEP 3
a) Place the MAIN FRAME [002] upon the Carton Lid and
poly foam as shown in the diagram below.
b) Remove 4 x BOLT [319] and 4 x WASHER [414] from
MAIN FRAME [002] with the tool provided.
c) Connect BATTERY CASE with CABLE[143A]to SENSOR
CABLE with BATTERY CABLE[706]
d) Assemble the STABILIZER - FRONT [005] and the MAIN
FRAME [002] with 4X BOLT [319] and 4 x WASHER [414] .
002
143A
706
16
a) Attach the WHEEL BRACKET ASSEMBLY to the MAIN
- FRAME [002] as shown in the diagram below taking care
to WHEEL BRACKET ASSEMBLY around the correct way.
b) Remove 2 x BOLT [367] and 2 x WASHER [414] from
MAIN FRAME [002]
c) Secure the WHEEL BRACKET ASSEMBLY with 2 x
BOLT [367] + 2 x WASHER [414] with the Tools provided
and tighten firmly.
367
414
016
a) Remove 4 x BOLT [319] and 4 x WASHER [414] from
ALUMINUM BEAM [001] with the tool provided.
b) Assemble the STABILIZER - REAR [006] and the ALUMI-
NUM BEAM [001] with 4 x BOLT [319] and 4 X WASHER
[414] .
319
006
414
CABLE TIE
005
STEP 4
with the tool provided.
002
005
414
STEP 5
006
319 319
414
414
001
STEP 6
a) Remove the partly assembled rower from the carton lid
and place it the correct way up as shown in the diagram
below.
b) Remove the SAFETY STRAP HOLDER .
c) Remove 6 x BOLT [319] and 6 x WASHER [414] from
PIVOT BRACKET [003] with the tool provided.
d) Assemble the ALUMINUM BEAM [001] and the PIVOT
BRACKET [003] with 6 x BOLT [319] and 6x WASHER [414].
But note not to tighten the BOLT [319].
NOTE: When assembling the ALUMINUM BEAM [001]
with the PIVOT BRACKET [003], make sure the HANDLE
GRIP [004] is not touching the PIVOT BRACKET [003] in
order to avoid the HANDLE GRIP [004] being scratched
by the ALUMINUM BEAM [001].
001
319
414
003
004
SAFETY
STRAP
HOLDER