Cabling The Optical Sfp+ Interface - Cisco ASR 5000 Series Installation Manual

▀ Cabling the Optical SFP+ Interface

Cabling the Optical SFP+ Interface
To interconnect the optical SFP+ interface on the XGLC, follow the instructions below.
Important:
assure proper reconnection should the card need to be serviced.
W
ARNING
W
ARNING
Avoid exposure to laser radiation and do not look into open apertures. Be sure to keep the cover on the interface
when it is not in use.
W
ARNING
schauen, um Augenverletzungen zu vermeiden. Nicht genutzte Buchsen mit der entsprechenden Kappe verschliessen.
Step 1
Remove the cover from the SFP interface.
Step 2
Insert the optical cable from a network device into the interface and ensure that it is securely in place.
▄ ASR 5000 Installation Guide
136
Be sure to label the interface cable with its destination prior to connecting it to the XGLC. This will
:
Only trained and qualified personnel should install, replace, or service this equipment.
:
Invisible laser radiation may be emitted from the aperture of the port when no cable is connected.
:
Laser Klasse 1 - nur speziell ausgebildetes Personal darf dieses Geraet warten. Nicht in den Laser
Cabling the Gigabit Ethernet Line Cards