Re-Installing Chassis Sub-Components - Cisco ASR 5000 Series Installation Manual

Chassis Installation

Re-Installing Chassis Sub-components

If you performed the procedure in the
procedures described below to re-install the sub-components of the chassis.
Caution:
to the components. Failure to do so could result in damage to sensitive electronic components and potentially void your
warranty.
Step 1
Re-install the PFUs into the chassis.
Step a
Filter Unit 1 and Power Filter Unit 2.
Step b
chassis.
Reducing the Weight of the Chassis Prior to Installation
During installation, maintenance, and/or removal, wear grounding wrist straps to avoid ESD damage
Locate the PFU bays at the lower-rear of the chassis. The bays are labeled from left to right Power
Slide the PFU assembly into the PFU bay labeled Power Filter Unit 1 until it is flush against the
Installing the Chassis ▀
section, complete the
ASR 5000 Installation Guide ▄
79