Rcc Run/Fail Led States - Cisco ASR 5000 Series Installation Manual

Applying Power and Verifying the Installation
Figure 59.

RCC Run/Fail LED States

The RCC Run/Fail LED indicates the overall status of the card. This LED is illuminated steady green during normal
operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 77. RCC Run/Fail LED States
Color Description
Green Card powered with no errors detected
Red Card powered with error(s) detected
None Card powered with error(s) detected
RCC LEDs
Troubleshooting
None needed.
Errors were detected during the POSTs. It is likely that the errors were
logged to the system's command line interface during the boot process.
Verify that the POWER LEDs on the PFUs are green. If they are not, refer
to
Verify that the power source is supplying ample voltage and current to the
chassis.
Verify that the card is properly installed per the instructions in this
document.
If all of the above suggestions have been verified, it is possible that the
RCC is not functional. Please contact your service representative.
Checking the LED on the PFU
Verifying the Installation ▀
for troubleshooting information.
ASR 5000 Installation Guide ▄
183