Cabling The Optical Sfp+ Interface - Cisco ASR 5000 Installation Manual

Cabling the Gigabit Ethernet Line Cards

Cabling the Optical SFP+ Interface

To interconnect the optical SFP+ interface on the XGLC, follow the instructions below.
Important
Only trained and qualified personnel should install, replace, or service this equipment.
Invisible laser radiation may be emitted from the aperture of the port when no cable is connected. Avoid
exposure to laser radiation and do not look into open apertures. Be sure to keep the cover on the interface
when it is not in use.
Laser Klasse 1 - nur speziell ausgebildetes Personal darf dieses Geraet warten.
Nicht in den Laser schauen, um Augenverletzungen zu vermeiden.
Nicht genutzte Buchsen mit der entsprechenden Kappe verschliessen.
Step 1
Remove the cover from the SFP interface.
Step 2 Insert the optical cable from a network device into the interface and ensure that it is securely in place.
Be sure to label the interface cable with its destination prior to connecting it to the XGLC. This will assure
proper reconnection should the card need to be serviced.
Cabling the Optical SFP+ Interface
ASR 5000 Installation Guide
113