Spio Active Led States; Spio Standby Led States - Cisco ASR 5000 Series Installation Manual

Applying Power and Verifying the Installation

SPIO Active LED States

The Active LED on the SPIO indicates that the software is loaded on the card and that the card is ready for operation.
For the SPIO installed in chassis slot 24, this LED is steady green during normal operation. For the SPIO installed in
slot 25, this LED is off during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 60. SPIO Active LED States
Color Description
Green Card is active
None Card is not receiving power.
OR
Card is in Standby Mode.

SPIO Standby LED States

The Standby LED on the SPIO indicates that software is loaded on the card and that it is serving as a redundant
component. For the SPIO installed in slot 25, this LED is illuminated steady green during normal operation. For the
SPIO installed in slot 24, this LED is off during normal operation.
If the LED is not green, use the troubleshooting information in the table to diagnose the problem.
Table 61. SPIO Standby LED States
Color Description
Green Card is in redundant mode
None Card is not receiving power.
OR
Card is in Active Mode.
Troubleshooting
None needed for SPIO in slot 24. If green for SPIO in slot 25, verify that SPIO in
slot 24 is installed according to the instructions in this document.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to
troubleshooting information.
Check the state of the Standby LED. If it is green, the card is in standby mode.
Refer to the System Administration Guide for information on making the card
active
Troubleshooting
None needed for SPIO in slot 25. If green for SPIO in slot 24, check the status of
the SMC installed in slot 8.
If the SMC in slot 8 is in standby mode, it is possible that there is a configuration
problem.
Verify that the Run/Fail LED is green. If so, the card is receiving power and
POST test results are positive. If it is off, refer to
troubleshooting information.
Check the state of the Active LED. If it is green, the card is in active mode.
Verifying the Installation ▀
SPIO Run-Fail LED States
SPIO Run-Fail LED States
ASR 5000 Installation Guide ▄
for
for
169