Cisco ASR 5000 Series Installation Manual page 125

Cabling the Fast Ethernet (10/100) Line Card
Refer to the following figure and table for pinouts for the RJ-45 Ethernet ports.
Figure 42. 10/100 Ethernet Interface Pinouts
Table 39. 10/100 Ethernet Interface Pinouts
Pin 100Base-T 100Mbps Cat5
1 TX+
2 TX-
3 RX+
4 Not applicable
5 Not applicable
6 RX-
7 Not applicable
8 Not applicable
RX = Receive Data TX = Transmit Data
Important:
This will assure proper reconnection should the card need to be serviced.
To cable the FLC2, simply plug an STC Ethernet cable from a network device into the desired port.
Be sure to label the interface cables with their destinations prior to connecting them to the FLC2.
FLC2 Interfaces ▀
ASR 5000 Installation Guide ▄
125