Installing Application Cards - Cisco ASR 5000 Series Installation Manual

Application Card Installation

Installing Application Cards

The installation procedure is identical for all application cards. This section provides the instructions for installing
application cards in the chassis.
Caution:
ESD damage to the components. Failure to do so could result in damage to electrical components and could potentially
void your warranty.
Step 1 Determine the type of application card you are installing. Each application card is identified by the text near the bottom
of its front panel.
Step 2
Determine which chassis slot to install the card in based on the information in
Assignments.
Step 3
Remove the blanking panel, if one is installed, covering the slot.
Step a
Step b
the chassis slot.
Step 4
Slide the interlock switch on the card fully downward and flip both ejector levers fully outward and away from the front
panel.
During installation, maintenance, and/or removal, wear grounding wrist and/or heel straps to avoid
Use a Phillips #2 screwdriver to loosen the screws at the top and bottom of the blanking panel.
Holding the screws on the blanking panel, pull the blanking panel away from the chassis to expose
Installing Application Cards ▀
Chassis Slot Numbering and
ASR 5000 Installation Guide ▄
87