Peripherals; Heater - Honeywell Thor VM1 User Manual

Tap the drop-down box to view a list of pre-configured connection settings.

Peripherals

Start > Settings > Control Panel > Peripherals
This panel is used to enable and disable the touch screen defroster.
Factory Default Settings

Heater

(page 5-82)
Defroster
Defroster Trip Point
Auto-off (page 5-83)
AutoOff
AutoOff timeout
Shutdown only if terminal is idle
Shutdown only if truck power lost Disabled
Heater
Note: Settings have no effect if the defroster is not installed.
The screen displays the information about the defroster:
• If the defroster is installed
• The current state of the defroster, ON or OFF
• If the defroster is Enabled or Disabled
• The defroster trip point.
Tap the Test button to determine the presence of the defroster. Use this button when the front panel of the Thor VM1
has been swapped. For example, if the Thor VM1 did not contain a defroster but a new front panel with a defroster is
installed, tap the Test button to update the defroster presence status on this tab.
If a defroster is installed, the defroster can be switched between the Enabled and Disabled states using the radio but-
tons on this tab. The default is Enabled.
Specify the Defroster trip point. The default trip point is either 0º C (32º F) or 40º C (104º F) depending on the ver-
sion of the operating system installed.
5 - 82
Enabled (if installed)
0º C (32º F), or 40º C (104º F)
(depends on OS version installed)
Disabled
15 minutes
Checked