Status Popup - Honeywell Thor VM1 User Manual

CapsLock
By default, CapsLock is disabled after a warmboot. To enable CapsLock after a warmboot, click this checkbox.
Touch Screen Disable
By default, the Thor VM1 touch screen is enabled. To disable the touch screen after a warmboot, click this check-
box.
Note: If the touch screen is disabled on a Thor VM1 with the 12 key keypad, you must use a USB mouse or
keyboard attached to the Thor VM1 to access this tab to re-enable the touch screen.
Enable Keypad Backlight
By default, the keypad backlight default setting is to follow the display backlight setting until it is changed by the
user.
Click the checkbox to disable the keypad backlight.
Enable Auto-On
When Auto-On is enabled, the Thor VM1 boots when external power is applied.
When Auto-On is disabled:
• if the ignition input signal is connected, when ignition changes from Inactive to Active the Thor VM1 boots.
• if the ignition input is not connected, the Thor VM1 only boots when the power button is pressed.
The default is disabled.

Status Popup

Options on this tab configure the Status Popup window. When the Status popup window is displayed, it is placed on
top of the window in focus and hides any data beneath it. It is closed by pressing the assigned Status User or Status
Admin key sequence.
Using the KeyPad (page 5-69) control panel, the System Administrator must first assign a Status User key sequence
for the end-user when they want to toggle the Status Popup Window on or off.
The System Administrator must also assign a Status Admin key sequence to perform the same function. Status
popup window display options (taskbar icons) are assigned on the Status Popup tab. E.g. AC Power, ActiveSync,
WLAN radio, CapsLock, Network status, Bluetooth status, etc.
The default for the User and Admin status popup windows is to show all status information. The 5 second timeout to
remove the status popup from the display is disabled by default for the User and Admin status popup windows.
5 - 79