Honeywell Thor VM1 User Manual page 66

6. Connect the ground (green) wire from the Thor VM1 to the GND terminal on the input side of the DC/DC
power supply.
7. Route the wiring from the DC/DC power supply to the vehicle's electrical system. Do not connect to vehicle
power at this time.
8. Strip the wire ends and connect to the input side of the DC/DC power supply.
9. Use looms and wire ties to secure all wiring as shown.
10. Reattach the cover with the screws.
11. Connect the DC/DC power supply to the vehicle's electrical system as directed below:
For battery powered vehicles:
V + is connected to battery positive.
IN
Vi - must be connected to battery negative.
N
GND must be connected to the vehicle chassis ground.
For internal combustion engine powered vehicles:
V + is connected to battery positive.
IN
Vi - is connected to battery negative.
N
GND is connected to the vehicle chassis ground, which can also be battery negative.
12. While observing the
actual battery terminals of the vehicle. When available, always connect to unswitched terminals in the vehicle
fuse panel, after providing proper fusing.
ATTENTION: For uninterrupted power, electrical supply connections should not be made at any point
after the ignition switch of the vehicle.
13. Use proper electrical and mechanical fastening means for terminating the cable. Properly sized "crimp" type
electrical terminals are an accepted method of termination. Select electrical connectors sized for use with
18AWG (1mm
14. Provide mechanical support for the cable by securing it to the vehicle structure at approximately one foot inter-
vals, taking care not to over tighten and pinch conductors or penetrate the outer cable jacket.
15. Connect the watertight connector end of the power cable to the Thor VM1 Quick Mount Smart Dock power
connector by aligning the connector pins to the power connector; push down on the watertight connector and
twist it to fasten securely.Flip the power switch on the back of the dock to On.
16. Secure the power cable to the Thor VM1 using the
17. Place Thor VM1 in the Dock
18. If using the
19. Press the
20. Press the
Once installation is complete, remember to start the Thor VM1 and configure the Auto-On behavior.
See the Misc tab of the
Note: Ignition control is not available for trucks over 60VDC.
4 - 22
Fuse Requirements
2
) conductors.
(page 4-2)
Screen Blanking (page 4-30) feature, install the screen blanking box or switch.
Power Switch (page 3-6) on the back of the Thor VM1 dock.
Power Button (page 3-6) on the front of the Thor VM1 to turn on the Thor VM1.
Options (page 5-78) control panel.
(see page 4-20) connect the power cable as close as possible to the
Strain Relief Cable Clamps (page 4-13).