Screen Control; Screen Blanking - Honeywell Thor VM1 User Manual

Screen Control

Start > Settings > Control Panel > Screen Control
Set screen properties for the Thor VM1.
Factory Default Settings
Screen Blanking (Blackout)
Enable screen blanking
Screen on delay (ms)
COM Port
Current Level
LCD Brightness (%)
Ambient Light (%)
Automatic Brightness Control
Automatic brightness control is not available on a Thor
VM1 with an outdoor display.
Enable automatic brightness
control
Low to medium light level (%) 25
Medium to high light level (%) 75
Note: If Automatic Brightness Control is enabled for an outdoor display, the value for LCD Brightness depends on the
Ambient Light %. Otherwise, the display defaults to 100% brightness.
Note: There is no default value for Ambient Light % as it varies depending on the level of light where the Thor VM1 is
located. If the Thor VM1 has an indoor display it does not have an ambient light sensor and the Ambient Light % is
always 0.
Note: Touch screen defroster controls are located on the

Screen Blanking

See Screen Blanking
Do not enable Screen Blanking until the cable is properly connected to the specified COM port.
Screen blanking allows the Thor VM1 display to automatically be turned off whenever the vehicle is in motion. When
the Thor VM1 display is off due to vehicle motion, the integrated keypad backlight remains on.
5 - 88
Disabled
1000
none selected
100 (see note)
(see note)
Disabled
(page 4-30) for the hardware necessary for screen blanking.
Peripherals (page 5-82) control panel.