Battery; Bluetooth - Honeywell Thor VM1 User Manual

Battery

Start > Settings > Control Panel > Battery
This panel is used to view the status and percentage of power remaining in the Thor VM1 UPS battery.
The battery gas gauge icon resides in the system tray and shows four levels of charge – 100%, 75%, 50%, 25%. At
a point below 25% the gas gauge icon will turn red indicating the battery is low.
The battery gauge icon is enabled by default, but can be disabled on the Thor VM1 Battery control panel. The UPS
LED turns red when there is approximately 2 minutes of run time remaining.
Jacked is shown in the Status box when the UPS battery is receiving external power.

Bluetooth

Start > Settings > Control Panel > Bluetooth
Discover and manage pairing with nearby Bluetooth devices.
Factory Default Settings
Settings (page 5-32)
Turn Off Bluetooth
Computer is connectable
Computer is discoverable
Prompt if devices request to pair Enabled
Continuous search
Filtered Mode
Printer Port on COM 7:
Logging
Computer Friendly Name
Reconnect (page 5-33)
Report lost connection
Report when reconnected
Report failure to reconnect
Clear Pairing Table on boot
Auto Reconnect on Boot
Auto Reconnect
Bluetooth taskbar Icon state and Bluetooth device Icon states change as Bluetooth devices are discovered, paired, con-
nected and disconnected. There may be audible or visual signals as paired devices re-connect with the Thor VM1.
• The default Bluetooth setting is On.
• The Thor VM1 cannot be discovered by other Bluetooth devices when the Computer is discoverable option is disabled
(unchecked) on the Settings panel.
Enabled
Enabled
Disabled
Disabled
Enabled
Disabled (unchecked) by default in both Filtered and Non
Filtered Modes. The option is dimmed in Non Filtered
Mode.
Disabled
System Device Name
Enabled
Disabled
Enabled
Disabled
Enabled
Enabled
5 - 29