Output Mode - ABB ACS850 Manual

Output mode

In the Output mode, you can:
• monitor actual values of up to three signals
• change the direction of the motor rotation
• set the speed, frequency or torque reference
• adjust the display contrast
• start, stop, change the direction and switch between local and remote control.
You get to the Output mode by pressing
The top right corner of the display shows the
reference value. The center can be configured to
show up to three signal values or bar graphs; see
page 31 for instructions on selecting and modifying
the monitored signals.
How to change the direction of the motor rotation
Step Action
1. If you are not in the Output mode, press
until you get there.
2. If the drive is in remote control (REM shown on the status
line), switch to local control by pressing
briefly shows a message about changing the mode and
then returns to the Output mode.
3. To change the direction from forward (
status line) to reverse (
vice versa, press
How to set the speed, frequency or torque reference in the Output mode
See also section Reference Edit
Step Action
1. If you are not in the Output mode, press
until you get there.
EXIT
LOC
REM
shown on the
shown on the status line), or
DIR
.
on page 49.
EXIT
The ACS850 control panel 23
EXIT
repeatedly.
LOC
DIR
Display
repeatedly
REM
DIR
LOC
. The display
DIR
Display
repeatedly
REM
DIR
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU
30.00rpm
49. 10
Hz
0. 50
A
10. 7
%
00:00 MENU