Unpacking The System; Component Installation Procedure; Tools Required - Infortrend EonStor GS 3000 Series Hardware Manual

Unpacking the System

Use the "Unpacking List" to cross check all components have been received. The
basic contents include one GUI CD pack, Quick Installation Guide and RAID
Enclosure Installation Guide. For details on each slide rail kit contents, please refer
to specific kit installation details in this manual.

Component Installation Procedure

Please install components in the following order:
1. Rackmount rails onto the enclosure / rack / cabinet
2. Enclosure onto the slide rail and into the cabinet
3. Hard drives into drive trays and then into the enclosure.
4. Drive trays (with or without hard drives) into the enclosure
5. If super capacitor / FBM were purchased as an optional component, the controller
must be removed from the enclosure for installation.
NOTE
For detail procedures from step 3 and onwards, please refer to the earlier sections in
this hardware manual.

Tools Required

For each of the slide rail installation procedures, you will need the following tools:

One medium sized Phillips screwdriver

One small sized Phillips screwdriver

One medium size flat blade screwdriver
126