Installing The Hard Drive Into Drive Tray - Infortrend EonStor GS 3000 Series Hardware Manual

Installing the Hard Drive into Drive Tray

Open the bezel by pressing the release button and gently pull out the tray.
Place the hard drive into the drive tray, making sure that the interface connector is
facing the open side of the drive tray and its label side facing up.
If you want to install a SAS drive, an installed MUX board must be removed first.
Adjust the drive location until the mounting holes in the drive tray are aligned with
those on the hard drive. Secure the drive with four of the supplied flat-head screws.
3.5 inch
2.5 inch SATA HDD
2.5 inch SAS HDD
Installing a 3.5" SAS / NL-SAS / SATA drive
2.5 inch SATA HDD
Installing a 2.5" SAS / SATA drive
2.5 inch
2.5 inch SATA HDD
2.5 inch SATA HDD
2.5 inch SAS HDD
41
2.5 inch SAS HDD
2.5 inch SAS HDD