Factory Notification; Display Cover Removal And Installation; Svi Ii Esd Pneumatic And Display Covers - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Factory Notification

Report any failures that are detected and that compromise functional safety to the factory.
Sales Office locations are listed on the back cover of this document.

Display Cover Removal and Installation

The cover with display (Figure 77) is standard with the SVI II ESD. If you to replace the display
cover, follow the instructions below for removal and installation.
Tools Needed for Cover Replacement
5 mm hex key for the cover
3 mm hex key for the lanyard
Removing the SVI II ESD Display Cover
To remove the SVI II ESD display cover:
1. Using a 5 mm Hex key unscrew the four screws around the perimeter of the SVI II ESD
cover and lift the cover off the positioner.
Pneumatic
Cover
132 |
=GE Oil & Gas
GE does not assume responsibility for the selection, use, or
NOTE
maintenance of any product. Responsibility for proper selection,
use of any GE product remains solely with the purchaser and
end-user. The SVI II ESD requires recertification which must be
performed by factory authorized personnel trained to repair
Safety Devices.
Figure 77 SVI II ESD Pneumatic and Display Covers
© 2016 General Electric Company. All rights reserved.
Display
Cover