Making Connections To The Terminal Board - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Making Connections to the Terminal Board

Each terminal block on the terminal board has a cage clamp connector. One side of the
connector has the actual connection for the wire, with a lever at the top. If there is an option
present that is not properly connected to the terminal board or if adding a new option,
connect the wires from the option as follows:
1. If the option's wires have not been stripped, strip the insulation at the end of wires.
2. Locate the correct terminal block on the terminal board (see Figure 54 on page 81).
3. Push the lever back at the top connector until you see the opening for wire insertion. The
connectors are spring activated and may require a lot of pressure to move the lever.
4. Insert the wire into the opening and release the lever.
© 2016 General Electric Company. All rights reserved.
Improperly or inadequately grounded installations can cause
NOTE
noise or instability in the control loop. The internal electronic
components are isolated from ground. Grounding the case is
unnecessary for functional purposes but grounding the case may
be necessary to conform to local codes. Side loading the cage
clamp lever can cause damage.
Masoneilan SVI II ESD Installation and Maintenance Manual
| 83
=