Available Models; About This Manual - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Smart valve interface with sil3 emergency shutdown pst controller

Table of Contents

Installing ValVue ESD

ESDVue is shipped on a CD included with every SVI II ESD. Place the CD in the computer CD

drive and run ValVue ESD Installer.exe. Follow the instructions of the installer program.

Advanced and Online Diagnostics

One of the important safety features of the SVI II ESD is the ability to test functionality of the

instrument. In addition to running a Partial Stroke Test (PST), ValVue ESD provides advanced

diagnostic capabilities and allows you to test the SVI II ESD terminal board and pneumatics

and to run extended testing on the actuator. The diagnostics area of the PST screen provides

access to all the diagnostic testing, shows the results from current testing and allows you to

load and view historical data.

All diagnostic tests are performed on the PST screen, in ValVue ESD. For more details on the

use of ValVue ESD software, refer to the ValVue ESD User's Guide. Contact the factory or your

local representative to obtain licensing information.

Contact the Factory

For the most recent software visit our SVI II ESD web site at: www.ge-energy.com/valves.

Available Models

There are three models of the SVI II ESD available:

ASD - Analog Safety Demand; 2 Wire Analog Trigger, 4 - 20 mA signal, 2 wire

installations with superimposed HART

DSD - Discrete Safety Demand; 2 Wire Discrete Trigger, 24 VDC, 2 wire installations with

superimposed HART

A/DSD - Analog Setpoint with Discrete Safety Demand; 4 Wire Discrete Trigger, 4 - 20

mA signal, 2 wire installations with superimposed HART

system and 24 VDC 2 wire for Safety System.

The SVI II ESD Instruction Manual is intended to help a Field Engineer install, setup, and

calibrate an SVI II ESD in the most efficient manner possible. This manual also provides

in-depth information on SVI II ESD software, digital interfaces, operation, intrinsic safety

configurations, and specifications. If you experience problems that are not documented in this

guide contact the factory or your local representative. Sales offices are listed on the back

cover of this manual.

32 |

=GE Oil & Gas

communications

communications for control

Table of Contents