Table of Contents
Advertisement
The contents of this publication are presented for informational purposes only, and while
every effort has been made to ensure their accuracy, they are not to be construed as
warranties or guarantees, express or implied, regarding the products or services described
herein or their use or applicability. We reserve the right to modify or improve the designs or
specifications of such products at any time without notice.
Display Cover Removal and Installation
The cover with display (shown in Figure 19) is standard with the SVI II ESD. If you to replace the
display cover, follow the instructions below for removal and installation.
Tools Needed for Cover Replacement
5 mm hex key for the cover
3 mm hex key for the lanyard
Removing the SVI II ESD Display Cover
To remove the SVI II ESD Display cover:
1. Using a 5 mm Hex key unscrew the four screws around the perimeter of the SVI II ESD
cover.
2. Lift the cover off the PST controller.
Pneumatic
Cover
© 2016 General Electric Company. All rights reserved.
Figure 57 SVI II ESD Pneumatic and Display Covers
Display
Cover
Masoneilan SVI II ESD Installation and Maintenance Manual
| 85
=
Advertisement
Table of Contents
Troubleshooting
