Check-Out With A Hart® Handheld Communicator - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Check-out with a HART
onnect the HART
C
Refer to Product Manual for HART
device.
Input Signal
Be sure that configuration lock jumper is in unlock position. When the jumper is in lock
position (shorting the two-pin header) the HHC is not allowed to make any changes. However,
parameters are readable. If fault messages appear, they must be handled before proceeding
®
with HART
cleared. For example, the following message is displayed if the instrument has been serviced
and the air is not connected.
© 2016 General Electric Company. All rights reserved.
®
Handheld Communicator
®
Handheld Communicator (HHC) to the SVI II ESD as shown in Figure 60.
®
GE DPI620
Figure 60 SVI II ESD HART
communications. Before communications proceeds all error messages must be
NOTE "
Process applied to the non-primary variable is outside the
operating limits of the field device"
Communicator supplied with the HART
Configuration
Lock Jumper
20.00 mA
+
GE DPI620
®
Communicator Connections
Masoneilan SVI II ESD Installation and Maintenance Manual
®
Communication
-
| 95
=