Pre-Installation Issues; Storage; Unpacking; Installation - GE Masoneilan SVI II ESD Installation And Maintenance Manual

Pre-Installation Issues

Storage

If the SVI II ESD is stored for a long period of time, you must keep the housing sealed against
weather, fluids, particles, and insects. To prevent damage to the SVI II ESD:
Use the plugs provided with shipment to plug the ¼ NPT air connections, on the
positioner and on the air filter regulator set.
Do not allow standing water to accumulate in packaging.
Observe storage temperature requirements.

Unpacking

Exercise care when unpacking the control valve and its mounted accessories. The SVI II ESD
package contains a CD-ROM with ValVue ESD software and manuals.

Installation

The steps necessary to complete the SVI II ESD installation and software setup are outlined in
Table 4.
Step No.
1 Attach mounting bracket to the actuator.
2 Install the SVI II ESD magnetic assembly (rotary
valves only).
3 Assemble the SVI II ESD on the bracket that is
mounted to the valve actuator.
4 Connect the pneumatic tubing to the SVI II ESD.
5 Connect the air supply to the SVI II ESD.
6 Install the wiring for the SVI II ESD.
7 Connect the PST controller to the HART
Loop segment by installing the SVI II ESD wiring.
© 2016 General Electric Company. All rights reserved.
Failure to adhere to the requirements listed in this manual can
WARNING
cause loss of life and property.
Before installing, using, or carrying out any maintenance tasks
associated with this instrument, READ THE INSTRUCTIONS
CAREFULLY.
Table 4 SVI II ESD Installation Steps
Procedure
See page page 461 for rotary valve and page 466
for reciprocating valve instructions.
See page 461 for instructions.
See page 461 for rotary valve and page 466 for
reciprocating valve instructions.
See page 471 for instructions.
See page 473 for instructions.
See page 473 for instructions.
®
Control See page 476 for instructions.
Masoneilan SVI II ESD Installation and Maintenance Manual
Reference
=
| 57