Table of Contents
Advertisement
GASBOY Series 1000
Sometimes, when a pump is not operating properly, fuel can be dispensed but not recorded. This
is known as a no quantity transaction.
automatically disable a pump after a set number of consecutive no quantity transactions.
Typically, the number of no quantity transactions is configured to 3 or 5 but values can range from
1-99. If a pump becomes disabled in this manner, the PUMP # _ DISABLED message appears
on the direct printout as shown below. The pump remains disabled until you enable the pump
using the EP command.
Â
VT7PÂ97T@ÂAIRÂÂXADÂÂ@7VAÂÂÂÂÂVEIAÂÂRÆÂRTÂSW7PVEVaÂÂQ@QIÂÂÂATTQTÂ
)# Â %$#Â"(!#Â'%)&Â)" # %Â!%0#%Â #Â #ÂÂÂÂ! #ÂÂÂ %$"!Â
)#!Â((''Â!!""Â##$$Â)" # %Â!%0#% ! ! ÂÂÂ
RWIRÂÆ !Â@EU78HA@Â
)#"Â((''Â!!""Â##$$Â)" # %Â!%0#%Â $Â "ÂÂÂÂ! &!!Â
Â
8-8
You can set a system configuration parameter to
Â
Â
05/29/03
Advertisement
Table of Contents
