Table of Contents
Advertisement
CV - CLEAR VEHICLE FILE
Use the CV command only at initial start-up. This command erases any vehicles/equipment
previously stored in the system; they cannot be retrieved.
1.
At the
prompt, type CV. The system displays: CLEAR VEHICLE FILE? <Y OR N>
*
2.
Type Y and press RETURN to reset (erase) the vehicle file. Type N and press RETURN to
leave the vehicle file as is.
NOTE:
Only Y or N are valid responses; if you type anything else, the system re-prompts
you until you enter a Y or N.
If you attempt to clear the vehicle file while transactions are in progress, the
system displays: TRANS IN PROGRESS!
transactions active to use this command.
The
prompt reappears.
*
Example:
Â
9XÂ
Â
9HA7TÂXADE9HAÂBEHA5Â2aÂQTÂP4Âa
Â
Â
05/29/03
Â
↵
L/100KM or LPH Option
You must wait until there are no
19-3
Advertisement
Table of Contents
