Table of Contents
Advertisement
GASBOY Series 1000
Installing New Ribbon Spools
1.
Place the ribbon spool onto the left shaft with the spool-driving pins pointing toward the
printer (Figure 27-5 C).
2.
Feed the ribbon over the left ribbon guide, under the print head, and over the right ribbon
guide.
3.
Repeat Step 1 for the right spool.
4.
Rotate both spools to remove the slack from the ribbon.
5.
Return the paper cutter unit to the normal position and slide the cutter latch to the left to lock
(Figure 27-5 A).
6.
Perform a short self-test
7.
Return the printer slide assembly to its normal position and lock it in place with the hex head
screw.
8.
Close and lock the printer access door.
NOTE:
Make sure the printer door lock is drawn tight in order to insure a watertight seal.
27-6
Figure 27-5. Ribbon Installation Sequence
05/29/03
Advertisement
Table of Contents
