Table of Contents
Advertisement
Status Board Lamps
D1
+12 VOLTS
This lamp should be lit whenever SW1 (Power) is on.
D2
ON LINE
This lamp must be on to print receipts or do a self-test. If it is not on, momentarily press
SW4.
NOTE: This lamp does not have to be lit to feed paper (SW3).
D3
ALARM
This lamp will light when a mechanical failure occurs, or when the printer runs out of
paper.
Controller Board DIP Switch Settings
The controller board DIP switches are set at the
factory prior to shipment. For proper operation of
the printer, set the controller board switch settings
as shown in Table 27-3.
Table 27-3. DIP Switch Settings
DIP SW1
DIP SW2
1-1
ON
2-1
1-2
ON
2-2
1-3
ON
2-3
1-4
ON
2-4
1-5
OFF
1-6
ON
1-7
ON
1-8
OFF
NOTE: DIP switches are only read by the
controller at power up.
changes should be made with the power
off.
05/29/03
Table 27-2. Status Board Lamps
ON
ON
ON
OFF
DIP switch
Receipt Printer Maintenance
Figure 27-3. DIP Switches
27-3
Advertisement
Table of Contents
