Mitsubishi FX3U-232-BD User Manual page 181

FX Series PLC User's Manual - Data Communication Edition
Parallel Link
5.3 Communication Setting Using Parameter Method (FXGP/WIN)
Communication settings may be changed using the parameter method with GX Developer and FXGP/WIN for
Windows. This section describes how to change parameters with FXGP/WIN.
Ch2 cannot be set using FXGP/WIN.
5.3.1 Operating procedure
This subsection explains the serial communication setting method. Suppose that FXGP/WIN is already
started up.
1
Adjusting serial setting (parameter)
Double-click [Option] - [Serial setting (parameter)] from the toolbar.
The following dialog box appears according to absence/presence of parameter settings.
1. When there are no parameter settings
The dialog box shown below appears to indicate that there are no communication settings.
Click the [No] button.
In this case, the next step is not required.
2. When there are already parameter settings
The dialog box shown below appears to indicate that there are communication settings.
Click the [Clear] button to delete the communication settings from parameters.
Transfer parameters to the PLC using the following step.
2
Writing a sequence program (parameters) to the PLC
Select [PLC] - [Transfers] - [Write] from the toolbar, and click [OK].
5 Communication Setting (Initialization) in FX Programmable Controller
5.3 Communication Setting Using Parameter Method (FXGP/WIN)
A
B
C
D
E
F
G
H
I
Apx.
C-31