Table of Contents
Advertisement
Operation Instructions
The FD215CV-C-6 is continuously on but can be de-energized by removing power from the
video system. No pilot or aircrew action is necessary during flight or ground operation.
The operator will be able to change the video output from the FD215CV-C-6 using the video
source select button on the display.
When applying 28VDC power, the display will turn on and look for a valid input on the last
known source. If no input is found, the display will go to standby mode. Pressing the Select
button will select new video input.
Button Controls
Located on the front left side of the FD215CV-C-6 are 8 non-function bezel keys.
The monitor contains a standard USB 2.0 hub. A Type B USB connector for the host
computer is mounted on the rear panel. Dual USB Type A connectors are accessible on
the front panel. They conform to standard USB 2.0 power and data rate specifications.
They typically support Mouse, Keyboard, and Thumb drives. They supply USB 2.0
standard 500 mA charging current suitable for charging small cell phones and media
players. Charging compatibility on some personal electronic devices may be inhibited or
limited by the presence or absence of suitable drivers on the host computer. The 500 mA
charge current is not sufficient for larger personal electronic devices and larger tablets.
© 2017 FDS Avionics Corp.
All Rights Reserved.
Document Number:
MAN – FD215CV-C-6
Revision Date:
Rev:
B
Page 12 of 16
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
01/11/2017
Advertisement
Table of Contents
