Operation Instructions; Button Control - FDS FD151CV-C-HT Installation And Operation Manual

Operation Instructions

The FD151CV-C-HT is continuously on but may be de-energized by removing power
from the display system. No pilot or aircrew action is necessary during flight or ground
operation.
When applying 28VDC power, the display will turn on and look for a valid input. If no
input is found, the display will go to standby mode.
The unit may be turned on at -40°C, although no picture will appear on the screen. A
yellow LED in the bottom, center of the monitor indicates that the heater is on and the
unit is in pre-heat mode. Once the monitor has an internal temperature above 10°C, the
heater will shut off, however, the monitor will power on automatically when the internal
temperature reaches 0°C. A green LED at the bottom, right of the unit indicates that the
LCD has power. The monitor may then be operated normally.
Button Controls
Located on the front, bottom right of the FD151CV-C-HT are 5 buttons.
WARM UP
HEATER INDICATOR
LED
BUTTON
M
S
P
© 2017 FDS Avionics Corp.
All Rights Reserved.
Document Number:
MAN – FD151CV-C-HT
Activates the OSD menu or goes to previous menu.
Moves the highlight icon down to the function that user
wants.
Moves the highlight icon up to the function that user
wants.
Cycles through source inputs. (Since only S-Video is
available, all other inputs are disabled.)
Powers monitor on and off.
M
DESCRIPTION
Revision Date:
Rev:
05/05/2017
D
Page 7 of 11
S
POWER INDICATOR
LED
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com
P