Operation Instructions; Monitor Control Buttons - FDS FD70ARM Installation And Operation Manual

Operation Instructions

The FD70ARM is continuously on but can be de-energized by removing power from the
entertainment system. No pilot or aircrew action is necessary during flight or ground
operation.
The passengers will be able to change the video output from the FD70ARM using the
video source select switch on the LED monitor, or remotely throughout the cabin with the
included IR remote. Point the IR remote at the top of the LED to make changes.
When applying power, the display will turn on and look for a valid input on the last known
source. If no input is found, the display will go to standby mode. Pressing the Input Select
button (S) will select a new video input.

Monitor Control Buttons

Located at the bottom of the FD70ARM LED are five buttons and one status LED.
Operations are as follows:
BUTTON


S
M

© 2017 FDS Avionics Corp.
All Rights Reserved.
Document Number:
MAN – FD70ARM
FUNCTION DESCRIPTION
Adjust UP Incremental adjustment or Menu selection
Adjust DOWN Incremental adjustment or Menu selection
INPUT Press and select between VGA, Composite #1
SELECT and Composite #2.
MENU Pressing this will activate the Menu.
Green – on and operating; None – Off or standby
Status Light
Light Sensor Senses level of outside lighting
POWER On/Off
Revision Date:
Rev:
05/22/2017
G
Page 8 of 13
TECHNICAL SUPPORT
470-239-7421 or FDSAvionics.com