FD50HMT-R Additional Information The FD50HMT features a “face-out” display designed to mount on the side wall. From its deployed position, the FD50HMT can rotate up to 150 toward the viewer for the optimal viewing angle. The FD50HMT features adjustable, tensioning shoulder screws located at the top &...
DO-160E, Sections 7&8 Installation Instructions All cockpit accessory displays and cabin equipment, such as the FD50HMT, should be installed on a non-essential bus and have a dedicated circuit breaker. It is a requirement that a switch be installed so that the pilot can de-energize the system should it become necessary.
N/C* N/C* *Other input options are available for an additional cost, please contact FDS Avionics Corp. for more information. This unit features remote dimming which requires a 10k linear taper potientiometer. Wiring for remote dimming must be twisted and must be in its own three wire bundle.
Page 8 of 12 Operation Instructions When the FD50HMT is powered up, it will search for a video input on the last known source. If no video input is found, the display will go into standby mode. The FD50HMT is a single source video display.
Simply raise the level of backlighting to view the display. Is there a locking mechanism to keep the FD50HMT open? No, however the tension can be adjusted by tightening the two shoulder screws (one on top, one on bottom).
06/30/2017 MAN – FD50HMT Page 10 of 12 Technical Support Should you have any questions concerning this product or other FDS Avionics Corp. products, please contact our Product Support representatives at 470-239-7421. FDS Avionics Corp. 6435 Shiloh Road Alpharetta, GA 30005...
Limited Warranty All FDS Avionics Corp. (FDS) products are warranted to be free from material or manufacturing defects for a period of 24 months from the date of shipment for General Aviation customers or 12 months from the date of shipment for Government/Special Mission customers.