Paper Sizes That Allow Stapling - Oki B930 Service Manual

There are the following four stapling modes.
Front Staple (Corner) [Front Corner]
The Stapler staples a set of paper obliquely (45 degrees)
after the Rear Tamper aligns the paper to the front side.
Rear Staple (Corner) [Rear Corner]
This type of stapling is applied for paper with a width of
216 mm or more.
The Stapler moves to the rear corner and staples a set of
paper obliquely (45 degrees) after the Front Tamper
aligns the paper to the rear side.
Rear Staple (Straight) [Rear Straight]
This type of stapling is applied for paper with a width of
less than 216 mm.
The Stapler staples a set of paper in parallel with the
paper edge after the Front Tamper aligns the paper to the
rear side.
Dual Staple [Dual]
The Stapler staples a set of paper at fixed positions (front/
rear sides) in parallel with the paper edge, after the Front
Tamper aligns the paper to the specified position for each
paper size.

Paper Sizes That Allow Stapling

Paper size that allows stapling depends on stapling positions.
The following table shows paper sizes and the applicability of stapling for each staple position.
A3SEF
A4LEF
2-73
Front Rear Rear
Corner Corner Straight
Yes Yes No
Yes Yes No
Rear
Process direction
Front
FI6P013A1
Rear
Process direction
Front
FI6P014A1
Rear
Process direction
Front
FI6P015A1
Rear
Process direction
Front
FI6P016A1
Dual
Yes
Yes