Notes On Using The Wiring Diagram Between Parts - Oki B930 Service Manual

Tray2
- Connection between PWB A MCU F and TRAY2 FEED LIFT UP MOTOR
- Connection between PWB A MCU F and SENSOR (Tray2 Level Sensor)
- Connection between PWB A MCU F and SENSOR (Tray2 No Paper Sensor)
- Connection between PWB A MCU F and SENSOR (Tray2 Pre Feed Sensor)
- Connection between PWB A MCU F and SWITCH ASSY P S (Tray2 Size Sensor)
8 MPF
- Connection between PWB A MCU F and SENSOR ASSY-MPF
- Connection between PWB A MCU F and SOLENOID PICK UP
- Connection between PWB A MCU F and SENSOR-PHOTO IN (MPF No Paper Sensor)
9 ROS
- Connection between PWBA ESS and ROS ASSY-12
- Connection between PWB A MCU F and ROS ASSY-12
10 EXIT
- Connection between PWB A EXIT and SENSOR-PHOTO IN (OCT Home Sensor)
- Connection between PWB A EXIT and SENSOR-PHOTO IN (Full Stack Sensor)
- Connection between PWB A EXIT and MOTOR ASSY-OFFSET
- Connection between PWB A EXIT and PWB A MCU F
11 Controller
- Connection between PWB A EXIT and PWBA ESS

Notes on Using the Wiring Diagram between Parts

The following describes the legend of the wiring diagrams between parts shown on the following
pages.
NOTE The description of general symbols is omitted.
Symbols
P/J
XX
YY
Denotes a plug.
Denotes a jack.
Denotes Pin yy and Jack yy of the connector Pxx and Jxx.
4-4
Description